KLS High Pressure Lip Seals

KLS® spring-loaded lip seals are polymeric lip seals for applications having unidirectional rotation. They have a composite body construction consisting of rubber and extrusion resistant plastic. The seals were designed and successfully tested for service conditions where the pressure acting from the spring side of the seal is up to 1,000 psi (6.89 MPa) greater than the pressure of the seal lubricant. Qualification testing was performed at a surface speed of 543 feet per minute (2.76 m/s).

KLS High Pressure Lip Seals
KLS High Pressure Lip Seals

The high-pressure performance of the KLS seal is remarkable for a spring-loaded lip seal. This high-pressure seal performance is the result of hydrodynamic lubrication of the extrusion resistant plastic portion of the seal. This lubrication provided by a patented wave geometry on the low-pressure side of the seal. As rotation occurs, this geometry wedges a film of lubricant between the shaft and the plastic dynamic surfaces. Similar seals without the unique hydrodynamic waves failed in only a few hours at the same surface speed, and only 500 psi (3.45 MPa) differential pressure.

When KLS seals are used to retain a pressurized non-abrasive fluid, only one seal is required, and the seal lubricant can be supplied from a simple unpressurized gravity fed lubricator. For example, if the seal is located below the bearings, the seal can simply utilize the bearing lubricant to lubricate the dynamic sealing interface. The need for the pressure of the seal lubricant to be greater than or equal to the pressure of the environment is eliminated.

Additional information about KLS spring-loaded rotary lip seals and their implementation in your equipment can be found on our website at Kalsi.com or by contacting our helpful Kalsi Seals engineering team.