We recently blogged about a new generation of pressure retaining mud motor seals. These Extra Wide mud motor seals are designed to operate in mud motors that incorporate larger extrusion […]
Kalsi Engineering's blog
Announcing important advances in mud motor pressure retaining seals
Review of a mud motor design trend Mud motor sealed bearing assemblies (Figure 1) typically have a “pressure retaining seal” location where a rotary seal is exposed to the pressure […]
A 2,300 psi rotary shaft seal test with 0.015” radial extrusion gap clearance
A pair of 10.49” PN 682-21-303 extra wide type A Plastic Lined Seals™ was tested for 100 rotating hours at 2,300 psi (15.85 MPa) and 45 rpm (123.6 sfpm) using […]
Testing a 10.500” RCD seal at 1,500 psi and 50 rpm
Our KLS-brand high pressure lip seals were originally offered for sale after successful 1,000 psi testing of 3.375” diameter seals at 543 surface feet per minute (sfpm), duplicating the surface […]
Rotary shaft seal testing with drilling fluid and 100 psi ‘reverse’ pressure
Kalsi Engineering has tested various prototype rotary shaft seal designs where the pressure of the drilling fluid is 100 psi (6.89 bar) greater than the pressure of the seal lubricant. […]
Video showing a floating backup ring in operation
Introduction to high pressure seal implementation challenges Mechanical designers face five significant challenges when implementing high pressure rotary seals: shaft runout; shaft misalignment; shaft deflection; pressure-related hardware deformation; and the […]
An extreme high-pressure oil seal test (320 hours, 9,500 to 9,800 psi)
test This video highlights extreme high pressure rotary oil seal testing. The test was conducted at 141.4 sfpm (0.72 m/s) with an ISO 68 viscosity grade oil at 9,500 to […]
A new way to address circumferential seal slippage
Circumferential slippage of a seal relative to a housing can produce undesirable effects, such as increased seal and housing temperature and seal and housing wear. Kalsi Seals incorporating anti-rotation tangs […]
Announcing the release of KVAP® Version 4.2
Kalsi Engineering is excited to announce the release of Version 4.2 of the Kalsi Valve and Actuator Program (KVAP™) software. KVAP 4.2 is a culmination of a multiyear project to […]
A 1,500 psi rotary seal test with a 0.020” radial extrusion gap clearance
Our Super Wide™ rotary seals were designed for partitioning oil from drilling fluid in lubricant-overpressure types of equipment such as power swivels, where the lubricant pressure is intended to be […]